This listing is for a Inner Cam Bearing Puller and Installation ToolsDesigned for Twin Cam Models 2007 to Present.Dyna Models 2006 to Present.This set will remove and install the inner cam bearings on the 07 to Present Twin Cams and the 06 to Present Dyna.
Toyota's front wheel bearing design change requires a new procedure to remove the lock nut. The free wheel hub assembly's locknut is on the inside, so the hub must be removed to gain access. This wrench's four-pin design accommodates the four holes in each locknut, which prevents slippage under high torque requirements.
The OTC 1926 is specially designed and makes wheel bearing locknuts easy to remove or install. Itâ€™s made of high-strength steel and resists rounding out. Opening size is 6 point and 3-3/4â€. NOTE: Socket is designed for use with 3/4â€ square-drive manual tools only. Impact tool use voids socket warranty.
OTC 4507 Bearing Race and Seal Driver Set - 10 Piece
This permits installation of tapered bearing races and seals without damage to the component or housing. The tapered side of the driver is used to install races. It's simple; just invert the driver to the flat side to install seals. This great set includes the following: driver handle with bolt, plus these tool sizes: 1.565", 1.750", 1.965", 2.325", 2.470", 2.555", 2.830", 2.995" and 3.180".
Astro Pneumatic's bearing race and seal drivers set makes it easier to insert wheel bearing race and seals. One side of disc drives bearing race, turn discs over to drive seals. Set includes: 1.565", 1.750", 1.965", 2.325", 2.470", 2.555", 2.830", 2.995" and 3.180" disc sizes.
Simply place the bearing between the plastic cones, tighten and apply grease through the fitting on the end of the threaded shaft. Forces out old grease and evenly injects fresh grease. Cone diameter is 4-1/2 inch.
Self-contained bearing packer saves time and can be used anywhere. No air line or grease gun required. Packs 50 to 60 bearings without refilling. Transparent, impact resistant cup allows grease level check. Use on all cage-type roller and ball bearings up to 2" bore.
The OTC 1121 features knife-like edges which are easily placed behind the part to secure a gripping surface, even when clearances are extremely limited. When used with an OTC Grip-O-Matic puller, the puller jaws grip attachmentâ€™s outer edge; when used with a Push-Puller, the puller legs are threaded into the attachmentâ€™s two tapped holes. For use with OTC 1020, OTC 1022, and OTC 1023 pullers.
Pit Posse VT102 Harley Davidson Wheel Bearing Remover And Installer Tool
Manufacturer: Pit Posse
Brand: Pit Posse
Designed to remove and install 3/4 inch, 1 inch and 25mm sealed type wheel bearings from 2000 and up without harming wheels. This is Pit Posse's updated remover which now includes all 3 installers: 3/4 inch, 1 inch and 25mm pullers and installers. Includes instructions, manufacturer offers lifetime warranty.